- Shop Now
- Safety Gear
- Hypermotive Gear
BMR Lowering Springs, Set Of 4, Minimal Drop, Performance 15+ Mustang GT
There is nothing like the aggressive look of a car with the right stance! Over time, stock springs sag, get rusty, and simply wear out. BMR Suspension believes the right springs go beyond looks—your S550 needs to perform, too! All BMR springs are manufactured from chrome silicon high-tensile spring wire, and are cold wound on a CNC coiling machine. The CNC coiling head can adjust the spring diameter in real time to ensure that every spring is exactly the same. This guarantees that your right spring matches your left spring. Every BMR spring is compressed solid at the factory, not once, but twice. This gives the spring its permanent set, and guarantees no sag. BMR springs are stress-relieved at 750 degrees F, ensuring most stresses induced during the winding process are eliminated. All springs are then shot-peened to eliminate residual surface stresses. Many spring manufacturers skip this step, but BMR insists on this operation as part of our spring manufacturing process. Every spring is computer tested as the last step—every spring, not just a sample from each batch. Each spring is loaded in the spring tester at the factory, then compressed and the CNC load cell measures the force for a variety of spring lengths. This allows BMR to offer a LIFETIME WARRANTY against spring sag.
Blending aesthetics and performance, BMR has designed the SP763 for the power adder crowd who want to use their cars for a variety of performance applications without worrying about the front end sitting too low. These springs will lower your S550 7/8-inch in the front and 1/2-inch in the rear, and feature a fine-tuned spring rate to give you great all-around handling characteristics and a smooth ride. The linear spring rate offers plenty of support, keeping the body flat and level, while remaining soft enough for a comfortable ride on any road. When performance and looks are a must, rely on BMR Suspension!
BMR Suspension’s SP763 lowering springs are available in red powdercoat for long-lasting good looks. Installation time is about 3-4 hours. Proudly made in the U.S.A.
***NOTE: This product was not engineered for a V-6 or 4-Cylinder EB Mustang, nor has it been tested on them.***